click to go
click to go
click to go
click to go
click to go
click to go
click to go
click to go
click to go
click to go

 

 

Shutters

Shutter Installation Using Screws

For shutters sizes 55" and over, use six screws per shutter. For smaller sizes use four screws per shutter. See figures below right.

Step 1

Place the shutter next to the window and mark desired location against the wall or window. See Figure 1.

Step 2
When installing shutters smaller than 55" drill (4) 1/4" holes in the locations shown in Figure 2A.

If the shutter is 55" and over, drill (4) 1/4" holes and (2) 11/64" holes in the locations shown in Figure 2B.

Step 3

Reposition the shutter against the wall and screw it into place using the screws provided. Do not over tighten the screws. When installing a shutter 55" and over, screw the two center screws in first (the screws using the 11/64" holes).

 

Shutter Installation Using Shutter Loks

For use on any surface including: wood, aluminum, vinyl, stucco, hardboard, brick, or masonry.

Required for Installation:
Electric drill, 1/4" drill bit, hammer, and Shutter-Loks

Step 1
Place the shutter next to the window and mark desired location against the wall or window. See Figure 1 at right.

Step 2
For smaller sizes use four Shutter-Loks per shutter Figure 2A . For large sizes 55" and over, use six Shutter-Loks per shutter Figure 2B.

Step 3
To help ensure proper alignment mark or pre-drill holes using a 1/4" drill bit into the shutter before attaching it to the wall.

Step 4
With the shutter in location against the wall (figure 1), drill through the shutter into the wall surface 3 1/4" . Make sure you drill holes deep enough so the Shutter-Lok doesn't bottom out.

Step 5
Grasp the Shutter-Lok supporting shank and push it through the shutter hole and into the wall surface. Tap the Shutter-Lok gently with a hammer to snug the shutter against the siding. Do not over tighten , or this will cause the shutter to dimple.

Note:
To remove shutters do not attempt to pull out the Shutter-Loks. Simply use a pair of nips and slide them behind the shutter to cut the Shutter-Lok off at the shank.

 

 

 

NOTE: Because all of our shutters are ordered, and custom made to your specifications, we cannot accept returns because of incorrect measurements. Furthermore, the manufacturers warranty is defendant upon proper installation. If you feel that you are unable to complete a proper installation, we suggest you inquire about our installation services.

Click Here to Learn How to Measure for Shutters